Sunday, November 18, 2012

More progress

Made some good progress this week. The wiring is 98% done. I still need to attach the tail, head lights, gas sender and a few things like that after the body is on. I also got the Saturday breakfast guys help me lift the body on. Sure looks good to have it mated back to the chassis again. I flipped the master cutoff switch, hit the start switch, the volt meter shows voltage and the starter cranked the engine and no smoke leaks...a good sign !! This week I will continue the final wiring of the head lights, install the exhaust, work on the brake and clutch pedals, bleed the brakes...that will keep me busy for a bit. With the upcoming holiday weekend I probably wont get a whole lot done. Monday I have set aside to fix the seat heater in daughter Michelle's Denali...I promised to fix it for her. I will need to get the John Deere to the shop to install the snow blower before I need to use it. There will be hot rod time next week.

Monday, November 12, 2012

Nov 12th

A snee
k peak at the body..........................

Progress...Nov 12

Motor and trans is in,drive shaft in,
fuel line ran from rear to both carbs, the wiring is started. I made a harness with plugs for the below dash gauges. Next is cutting the holes for the tach and the speedo, wire the lights and then the starter, the dizzy and resistor. I hope to get some help Saturday morning after breakfast and get the body on the frame.

Thursday, November 1, 2012

more pics for Nov 1

Photos for the clutch and engine part.

November 1 ...a little progress

I've been busy doing other things instead of working on the B400. I did get a little progress made this last week or so. While I was waiting on some clutch parts I decided to make the kick panels. They are made from ABS plastic panel. I kind of like that stuff. I needed to mount the voltmeter in the right kick panel because the extra gauge panel is full. I am running 2 water temp gauges so the 4 gauge panel under the dash is full. To make the voltmeter fit in the kick panel I had to make a little pod or a bulge in it. I have done this on two other deuces in the past. I had saved the wood buck from the last jobs. The heat gun works wonders to heat the plastic soft, then carefully force it over the buck and apply a little more heat. You can feel when it is soft enough. After it cools, a hole saw makes a nice round hole, then pop the gauge into it. I had my neighbor machine a bushing so that I could use a real bearing for the pilot shaft instead on the bronze bushing that comes with the set up. Next was to drill and tap a hole in the aluminum bellhousing to attach the throwout bearing to. I drilled a small hole at the end of the bolt to attach the spring to. Thanks to friend Darrick, i used his bellhousing as a pattern. His flattie is torn down at the moment, so me taking the bell for a day or so worked out. Yesterday I got the trans and engine bolted together and installed into the chassis. Sure looks good in there. The firewall went back on and the radiator too. Speedway order will bring me more radiator hoses and Gates power clamps to finish it up.